SACair Forum

Well all i did was take my slide cover off for some lubing of the springs and what not. When i was done i slid it back on and the slide stuck. Now its stuck so bad it will not move a bit.

did you have a mag in it?

Also try tugging on the recoil spring guide that should be protruding just a tad from the front of the gun.

lol... if its stuck in an unnatural position just give it a GOOD bang towards the equilibrium point (if its stuck back hit it forward, stuck forward hit it back or maybe forward to get it off). Glocks are resiliant and you won't hurt it. Ken got his stuck one time and couldn't get it un done so i banged it a few times on his truks tailgate and it fixed

Negative Cambre is right pull on that OR hold the gun in one hand with barrel twords your right. push down on the shell extractor partand pull up on the slide at the same time (two parts they will move) then as they move push the slide back lik eit would move if u were fireing. Try that with negative cambers idea and it should work.

well after trying to get it off i just got pissed and walked away. To bad the slide cracked, like the top part pretty much is up like 1/2 cm. This sucks

what i did when my silde jammed was, hold down the slide removel switches, and band the back of the slide with a hammer, then it should move out on eatch bang. u will slightly chip paint off but thats it, then carefull put the slide back on.

ya the slide works fine now. It comes of a slides on ok, not as easy as it use to but still.