sharpshooterMay 19, 2007 8:18pm
Its Tanaka M40A1
HELPPPP!!!!!!!!!!!!!!!!
sharpshooterMay 20, 2007 1:16am
its missing the hop up rubber inside too ill just buy the G&G set lol no wonder it was so cheap
RazorOneMay 20, 2007 1:24am
hmmm the new hopup unit does not come with one? Well no one ever said our sport was cehap....lol
RazorOne
sharpshooterMay 20, 2007 1:36am
lol its actually gonna cost me 13 bucks to fix I cemented the hop up back together pretty well with epoxy all I need to by is the G&G rubber set. I hope I will like sniping. If I don't, I'll sell this gun and this will be all for nothing :(
RazorOneMay 20, 2007 2:31am
Well I could not quite understand your question....could you rephrase it? As to which to buy if that was the question. If it was me I would buy both as being it is a used gun and it a has a few minor issues I would buy both just to be safe having the new stuff installed to cure any future potential probs that might crop up...
RazorOne
RazorOneMay 20, 2007 2:41am
Given my limited knowledge of airsoft I would say ask snoopy or andrew. They both know far more then me when it comes to this stuff... Sorry I can't help you out with that question...
RazorOne
shadowstalkerMay 20, 2007 2:46am
One is to make your rifle a gas operated gun. The other is just the rubber. Gas guns can fluctuate ALOT on FPS. My suggestion is to stay spring.
All alone he turns to stone
metalmasterMay 20, 2007 2:50am
[quote="shadowstalker"]One is to make your rifle a gas operated gun. The other is just the rubber. Gas guns can fluctuate ALOT on FPS. My suggestion is to stay spring.[/quote]
sharpshooterMay 20, 2007 3:16am
[quote="shadowstalker"]One is to make your rifle a gas operated gun. The other is just the rubber. Gas guns can fluctuate ALOT on FPS. My suggestion is to stay spring.[/quote]
RazorOneMay 20, 2007 3:23am
I think if it is a gun that has the power control system valve(PCS) on the bolt then it is to replace it and make the gun full power. But don't quote me on that. With the PCS valve it allows you to vary the power output on the restricted tanaka guns. If your guns does not have a valve/dial type device on the bottom fore part of the bolt it is either a pre ban gun or a late export only model like mine. Snoopy or Andrew may know this one better then me...
RazorOne
sharpshooterMay 20, 2007 3:54am
thanks everyone, If I sell my M14 then I'll buy a lot of new parts for my M40
