So I have been noticing feeding problems with the V3 boxes when running highspeed internals. I have seen sector chips that are supposed to correct that problem, by delaying the tappet plate allowing bbs to feed better. Anyone use them?
I shoot Table Gypsies on sight!
Do different mags make a difference? I don't play enough to notice, but I did install one on a ver2 gearbox. Nifty little things.
Remove the first "real" tooth at the rear or the piston. Not the last large one but the first small one next to that. Your feeding problem will go away. I do this to ALL my gearboxes...enjoy...
You just got killed by a Daewoo Lanos...How You like me now?
I used to do that with my saw and it worked well. Dam I did not even thik about that !
I shoot Table Gypsies on sight!
Im pretty positive that should cure your problem. If not you can shave a tooth off the sector gear. Because there are fewer gears on the sector gear, you will be "delaying" the contact between the gear and the piston "longer" then by shaving teeth off the piston.
You just got killed by a Daewoo Lanos...How You like me now?
What also works in addition to shaving the 2nd tooth off the piston is placing a washer in between the piston and piston head to move the piston back a bit.
"If today is a good day to die, then how bad could it be to live today?"
Its working better now, but still not 100%.
I shoot Table Gypsies on sight!